User`s guide

Basic Installation AXIS 70/70U User’s Guide
10
Connecting the Scanner to the AXIS 70/70U
Caution!
AXIS 70
1. Switch off the scanning device and disconnect the AXIS 70 external power sup-
ply. The SCSI bus may become damaged if you connect or disconnect units when
power is on.
2. Connect the SCSI cable to the SCSI connector on the AXIS 70.
3. Connect the SCSI cable to the scanning device. The AXIS 70 uses a built-in SCSI
terminator. Note that the scanning device must also be terminated properly.
Refer to the documentation supplied with your scanning device.
AXIS 70U
1. Switch off the scanning device and disconnect the AXIS 70U external power
supply.
2. Connect the USB cable to the USB connector on the AXIS 70U.
3. Connect the USB cable to the scanning device.
Connecting the AXIS 70/70U to the Network
1. Connect your AXIS 70/70U to the network. The AXIS 70/70U is designed for 10
Mbps Ethernet and 100 Mbps Fast Ethernet networks and connects to the net-
work via a twisted pair category 5 cable (10baseT and 100baseTX).
2. Switch on the scanning device.
3. Connect the external power supply to the AXIS 70/70U. The network indicator
will flash during power up and self test. The following message will appear on
the display during self test (x.xx is the software version number, e.g. 1.00):
Note:
• Check that the power supply included with your AXIS 70/70U is marked with the correct
mains voltage.
The tri-colored Network indicator flashes:
• yellow - indicating network activity on a 10MB Ethernet network.
• green - indicating network activity on a 100MB Fast Ethernet network.
• red -indicating that the unit is not correctly connected to the network.