User`s guide

AXIS 5470e/570/670e User’s Guide Setup for NetWare
31
Setup for NetWare
NetWare Using NDPS over IP
Important:
Note:
Having assigned an IP address to the AXIS 5470e/570/670e as described in Assigning an IP address,
on page 9, you are now ready to install the AXIS 5470e/570/670e for NDPS printing over IP.
Follow the instructions below:
1. Connect the AXIS 5470e/570/670e to the NetWare network, if it is not already connected.
Refer to Connecting the Printer to the Network, on page 8 for more information.
2. Start the NetWare Administrator. Create an NDPS Manager object, if you do not have one
available.
3. Proceed to create the printer object as a public or controlled access printer.
Please refer to the appropriate Novell documentation for instructions on creating NDPS Manager
objects and the NDPS printers.
Notes:
If you want to print in NDPS mode, make sure that you have NDPS software installed on your
NetWare file server.
You can select to install the connected printers as Public or Controlled Access printers.
The HP-JETADMIN parameter of the AXIS 5470e/570/670e must be set to YES in order for the
communication between the AXIS 5470e/570/670e and the NDPS gateway to be enabled.
NDPS requires NetWare 4.11, or higher.
During the creation of the printer object, you must choose the IP address of the AXIS
5470e/570/670e.
To print using TCP/IP, Axis print server firmware 6.1 or later is required. In order to print using
IPX/SPX, Axis print server firmware 5.51 or later is needed.