User`s guide

AXIS 5470e/570/670e User’s Guide AS/400 TN5250E Printing

AS/400 TN5250E Printing

Before you begin:

The AS/400 Host System Checklist

Note:

1. Type WRKCTLD *VWS on the AS/400 command line and press Enter. Determine the

number of auto-configured virtual devices on your AS/400 system. Press F3.

2. Type DSPSYSVAL QAUTOVRT and press Enter. Make sure that the parameter is greater than

the number of auto-configured virtual devices. Press F3.

3. Type DSPSYSVAL QCHRID and press Enter. Note the system language (code page) for

future reference. Press F3.

4. Type WRKTCPSTS *IFC and press Enter to determine the IP address of the AS/400.

Press F3.

Configuring the AXIS 5470e/570/670e

Follow the instructions below to configure the AXIS 5470e/570/670e for TN5250E printing in

the AS/400 environment using a Web browser:

1. Start a Web browser, e.g. Internet Explorer or Netscape Navigator.

2. Enter the IP address or the host name of the AXIS 5470e/570/670e in the location field and

press the Enter key on your keyboard. The internal Web pages of the AXIS 5470e/570/670e

will appear.

Note:

• Make sure that the AS/400 host is running OS/400 V3R2 or higher with TCP/IP support installed and config-

ured.

• Make sure that the latest PTFs are installed. Information about which PTFs to use can be obtained from

http://as400service.rochester.ibm.com/

The AS/400 Parameter Checklist, on page 47 is a table where you can enter the values described in

this section for future reference.

To protect the admin pages and the Configuration Wizard from unauthorized use, enter a

password (default Pass) in the Root Password field under admin | General Settings.