User guide

ProJet

860Pro User Manual Troubleshooting the ProJet x60Pro

5/12/13

Solution - Print Heads

Troubleshoot using Section 7.3, ’Print Head Errors/ Weak Parts’.

Solution - Motion Problems

• Clean the Fast Axis Rails. See Section 3.4, ’Clean The Fast Axis Rails and Carriage’.

• Clean the Fast Axis Pulleys. See Section 6.6, ’Clean The Fast Axis Pulleys’.

• Clean the Slow Axis Rails and Pulleys. See Section 6.7, ’Clean The Slow Axis Rails and Pulleys’.

7.12 Miscellaneous Problems

7.12.1 Vacuum Has Low/No Suction

Explanation: This is usually an indication that the Debris Separator needs to be emptied and cleaned.

Solution:

• Remove the Debris Separator and empty the contents into a waste receptacle.

• Check that its gasket is not damaged. Also check that all four magnets are in place on the back of the

Separator. These magnets hold the Separator against the panel.

• When you replace the Debris Separator, ensure that it is flush against the panel.

• Check the vacuum hose is not plugged with debris.

• Check that the vacuum hose is not cut or torn.

If, after checking these items the problem persists, contact your Service Provider.