User guide

ProJet

860Pro User Guide Additional Operations

5/12/13

5.3 Add Binder

If there is not enough binder in one or more of the cartridges, 3DPrint displays BINDER LOW in the Printer

Status dialog.

Important: Do not add binder unless you are prompted to in the 3DPrint Printer Status dialog.

To add binder, follow the steps below.

1. Pull the empty binder cartridge out of its housing on the printer.

2. Get a new binder cartridge. Check the expiration date, and check the cartridge label for the correct

color and orientation. Match the cartridge color to the color label on the printer.

3. Insert the cartridge into its housing with the color marking on top. Ensure the cartridge is pushed all the

way in. You should feel it gently snap into place.

Important: If a cartridge does not snap into place, do not force it. Check the orientation and that it is

the correct color and try again.

5.4 Adding Core to the Feeder

3DPrint evaluates the geometry of the part to determine if there is enough Core material in the Feeder to

complete the build. If there is not enough, 3DPrint displays ADD CORE in the Printer Status dialog.

Important: Do not add Core to the Feeder unless you are prompted to in the 3DPrint

Printer Status dialog.

To add Core, follow the steps below.

1. Before adding any Core, be sure you have

• Vacuumed all Core out of the Build Bed, and from the Deck, Fast Axis, etc.

• Finished cleaning any parts in the Post Processing Unit.

• Vacuumed up any other Core needing cleanup.

2. Check the expiration date on the container.

3. Open the printer top cover and place the container inside.