User`s guide

AXIS 570/670 User’s Guide AS/400 IPDS over PPR/PPD Printing 15
8. Enter a FGID number at the Font Identifier (FONT) line. A list of all supported
FGIDs is available in the AXIS 570/670 User’s Manual.
9. Define the
Remote location (RMTLOCNAME). Use the IP address of the AXIS 570e/670e.
10. Enter the name of the previously created PSF configuration at the
User-defined object
(USRDFNOBJ): Object
line.
11. Enter the library of the previously created PSF configuration at the
User-defined object
(USRDFNOBJ): Library
line.
12. Enter
*PSFCFG at the User-defined object (USRDFNOBJ): Object type line.
13. Press the Enter key on your keyboard to create the printer device description.
Verifying the communication
Follow the instructions below to verify the communication by sending a print job to the AXIS
570e/670e:
1. Type WRKCFGSTS *DEV AX570PR1 on the AS/400 command line to display the
previously created printer device. The status of the printer device should be
VARIED OFF.
2. Vary on the printer device by typing
1 in the Opt field. Press ENTER.
3. Press F5 to refresh the display. The printer device should now be
VARIED ON.
4. Start the printer writer by typing STRPRTWTR AX570PR1 on the AS/400 command line.
Press ENTER.
5. Press F5 to refresh the display. The printer device should now be
ACTIVE/WRITER.
6. Direct a printout to this printer device. A successful printout verifies the communication link
between the AS/400 and the AXIS 570e/670e.
Note:
The AXIS 570e/670e is now ready for printing in the AS/400 environment.
In the example above, the logical printer PR1 is used and the printout is directed to the destination AX570PR1.
IBM AS/400