Installation guide

Installing the AXIS 570/670 MIO
Network setup is most easily done using the AXIS NetPilot™.
However, if you do not have any computers running Windows,
NetWare or NetBIOS/NetBEUI you may also use the printer’s front
panel for basic configuration. Both methods are fully described in
the User’s Manual.
Proceed with the following instructions, as appropriate for your
type of network. Refer to all relevant sections if you intend to use
the AXIS 570/670 MIO in a multiprotocol environment.
Netware
By following the instructions detailed below, install your AXIS
570/670 MIO with the AXIS NetPilot™ installation Wizard,
supplied on the AXIS Utilities disk. Please note that the AXIS
NetPilot™ software will require a Windows platform that uses
either NetWare or NetBIOS/NetBEUI.
1. Load the AXIS NetPilot™ software by following the instructions
on the label of the AXIS Utilities disk. After loading the software,
double click on the NetPilot™ icon.
2. The AXIS NetPilot™ will scan the network for Axis Network
Print Servers that have not been installed and your AXIS
570/670 MIO will subsequently feature as a New Axis Unit.
Select your AXIS 570/670 MIO from the Contents of ‘New Axis
Units’ and then click the Install icon. The Installation Wizard
will then guide you through the basic installation.
Should you require assistance with any of the operations click the
Help icon and follow the instructions provided in the Help window.
To set up print queues:
1. Select the Network Print Server to be set up by clicking its icon.
2. Choose Network from the Setup menu.
3. A new window will open that allows you to create print queues,
connect the AXIS 570/670 MIO to print queues, and select
either Print Server mode or Remote Printer mode for each
printer.
To set up the advanced operating parameters:
1. Select the Network Print Server to be set up by clicking its icon.
2. Choose Properties from the Setup menu.
3. A set of Property Pages are opened which allow you to set up the
way in which Print Server mode and Remote Printer mode
operate. You can also enable the frame types to be used.
The setup is now completed and you can close the AXIS NetPilot™.
Open a Windows application, e.g. Microsoft Word and then select
Print... to ensure that your printer appears as the default printer.
Make a test printout to verify that the AXIS 570/670 MIO is
functioning correctly.