Installation guide

Quick Installation Guide
This guide covers the installation and basic setup procedures for your
AXIS 570/670 MIO. If you need more detailed instructions, please
refer to the AXIS 570/670 MIO User’s Manual.
Hardware Installation
1. Remove the cover plate over the MIO slot.
2. Record the unit serial number. The serial number is the default
Ethernet or Node address which may found on the back of the
AXIS 570/670 MIO circuit board. You will need this number
during the network configuration.
3. Switch off the printer.
4. For AXIS 670 MIO only: Select the network Ring Speed using the
jumper S4. With the jumper in place, the network speed is 16
Mbit/s. Remove the jumper to select 4 Mbit/s.
5. Slide the AXIS 570/670 MIO board into place.
6. Tighten the two screws securing the rear panel.
7. Switch on the printer. The hardware installation is now complete.
AXIS 570 MIO
Ethernet 10baseT connector
Ethernet 10base2 connector
Network Indicator
Test Button
AXIS 670 MIO
Token Ring UTP Connector
Token Ring STP Connector
Ring Speed Jumper
Network Indicator
Test Button