User`s guide

AXIS 5470e/570/670e User’s Manual Section 5: Setting Up - IBM Mainframe

JES3 Initialization Below is sample JES3 statements for an TCP/IP attached AXIS

5470e/570/670e. In the example the JNAME=PRT1 have been used.

Note:

The following paragraphs describe the JES3 initialization statements

shown above, which are typical of the JES3 statements used with PSF.

For more detailed descriptions of all JES3 initialization statements,

refer to the JES3 initialization and tuning publication for your

operating system.

FSSDEF,TYPE=WTR,FSSNAME=FSS3,PNAME=SAMPPRO3,SYSTEM=SYS1,TERM=NO

DEVICE,DTYPE=PRTAFP1,JNAME=PRT1,JUNIT=(,SYS1,,ON),FSSNAME=FSS3

MODE=FSS,PM=(LINE,PAGE,),CHARS=(YES,GT12),

CARRIAGE=(TES,A868),CKPNTPG=100,HEADER=YES,WC=(C)

This is only an example. For specific coding for JES parameters, refer to the JES

publication for the level of JES you are using.