User`s guide

Section 5: Setting Up - IBM Mainframe AXIS 5470e/570/670e User’s Manual

PRTnnnn Statement Explanation

PRMODE

Specifies the data-set processing modes supported for the printer. It lists

all the PRMODE values that the printer accepts. If the AXIS

5470e/570/670e is connected to a PostScript printer, the correct setting

PRMODE=(PAGE,LINE,).. This setting indicates that

composed-page and line data sets can be printed.

SEP

Enables job-header and job-trailer separator pages to be produced.

Note1: If the Distributed Print Function (DPF) of PSF/2 is installed, you

may need to set this parameter to

YES.

Note2: This parameter is new in JES2 and replaces the SEP | NOSEP

parameter.

SEPDS

Enables formatted data-set header separator pages to be produced.

Note: This parameter is new in JES2 and replaces the SEPDS |

NOSEPDS parameter.

START

Specifies the way that the printer is started. The parameter value NO

specifies that the printer is to be started by an operator command. The

parameter value

YES specifies that the printer, if it is ready, is to start

automatically when JES2 starts processing.

Note: This parameter is new in JES2 and replaces the DRAIN | START

parameter.

TRKCELL

Specifies whether track-cell despooling is to be used or not. It is

recommended to set this parameter to

YES.

UCS

Specifies a default font. If you want to select a font in the startup

procedure instead of the JES2 default font, you should set this

parameter to