User`s guide

Section 5: Setting Up - IBM Mainframe AXIS 5470e/570/670e User’s Manual

Verifying the Communication:

Follow the steps below to test the communication by sending a print

job to the AXIS 5470e/570/670e.

1. Make sure the printer is connected to the AXIS 5470e/570/670e

and the corresponding LU in the host is activated.

2. Send a print job from the host.

The AXIS 5470e/570/670e is now ready for use. If needed, it can be

further adapted to your system using the AXIS NetPilot™, Web-

based configuration pages or IBM Printer Emulation. Please refer to

Appendix C - Extended IBM Printer Emulation, on page 245.

Note:

You can check the status of the TN3270E connection by printing a test page from

the Print Server. This is done by pressing the test button once. Make sure the

TN3270E status (St:) line for your server connection is defined as either:

• SSCP

• LU-1

• LU-3

For additional information about configuring other TN3270E servers, refer to the

Technical Notes via the AXIS Web pages.