User`s guide

AXIS 5470e/570/670e User’s Manual Section 5: Setting Up - IBM Mainframe
81
6. Specify the IP Address of the client(s) that you want to assign to
this LU. This is the IP address of the AXIS 5470e/570/670e, i.e.
the same as the INT_ADDR parameter in the Print Server.
7. Click OK.
Verifying the
Communication:
1. Activate the connection you created in step 2 of the above SNA
Server - AXIS 5470e/570/670e connection procedures. The status
of the connection should be “active”.
2. Make sure the corresponding LU in the host is activated.
3. Activate the TN3270 connection to the AXIS 5470e/570/670e.
The LUA should change status to SSCP.
4. Check that the printer is connected to the AXIS 5470e/570/670e.
5. Send a print job from the host.
The AXIS 5470e/570/670e is now ready for use.
Notes:
• You can check the status of the TN3270E connection by printing a test page
from the Print Server. This is done by pressing the test button once. Make
sure the TN3270E status (St:) line for your server connection is defined as
either:
•SSCP
•LU-1
•LU-3
• For additional information about configuring other TN3270E servers, refer to
the Technical Notes via the AXIS Web pages.