User`s guide

Section 4: Setting Up - AS/400 AXIS 5470e/570/670e User’s Manual
64
Verifying the
communication
Follow the instructions below to verify the communication by sending
a print job to the AXIS 5470e/670e:
Note:
1. Type WRKCFGSTS *DEV AXISPR1 on the AS/400 command
line and press Enter to display the previously created printer
device. The status of the printer device should be
VARIED OFF.
2. Vary on the printer device by typing
1 in the Opt field. Press
E
NTER.
3. Press F5 to refresh the display. The printer device should now be
VARIED ON.
4. Start the printer writer by typing STRPRTWTR AXISPR1 on
the AS/400 command line. Press Enter.
5. Press F5 to refresh the display. The printer device should now be
ACTIVE/WRITER.
6. Direct a printout to this printer device. A successful printout
verifies the communication link between the AS/400 and the
AXIS 5470e/670e.
The AXIS 5470e/670e is now ready for printing in the AS/400
environment.
AXISPR1 is an example. Refer to Creating a Printer Device Description
on page 59 for details.