User`s guide

Section 4: Setting Up - AS/400 AXIS 5470e/570/670e User’s Manual
50
9. Type DSPMODD QRMTWSC on the command line and press
Enter. Press F11 to display the keywords. Verify that the mode
description exists on the system and that it is configured as
presented in the example below. Use the command
WRKMODD QRMTWSC if you need to change a value.
Press F3.
Example:
10. Type DSPUSRPRF QUSER and press Enter. Make sure that the
QUSER Status is *ENABLED.
Example:
Display Mode Description S1032BB0
Modedescription.........: QRMTWSC
Class-of-service.........: #CONNECT
Maximumsessions.........: 57
Maximumconversations ......: 57
Locallycontrolledsessions ...: 56
Pre-establishedsessions.....: 0
Maximuminboundpacingvalue...: *CALC
Inboundpacingvalue.......: 7
Outboundpacingvalue ......: 7
Maximumlengthofrequestunit..: *CALC
Datacompression.........: *NETATR
Inbounddatacompression.....: *RLE
Outbounddatacompression ....: *RLE
Sessionlevelencryption.....: *NONE
Text...............: ThisModeisIBMSupplied
Bottom
Press Enter to continue.
Display User Profile - Basic
Userprofile...............: QUSER
Previoussign-on.............:
Sign-onattemptsnotvalid........: 0
Status..................: *ENABLED
Datepasswordlastchanged........: 08/08/00
Passwordexpirationinterval.......: *SYSVAL
Setpasswordtoexpired .........: *NO
Userclass................: *USER
Specialauthority ............: *NONE
Groupprofile ..............: *NONE
Owner ..................: *USRPRF
Groupauthority .............: *NONE
Groupauthoritytype...........: *PRIVATE
Supplementalgroups ...........: *NONE
Assistancelevel.............: *SYSVAL
Currentlibrary .............: *CRTDFT
More...