User`s guide

AXIS 5470e/570/670e User’s Manual Section 4: Setting Up - AS/400
49
Example:
6. Type DSPSYSVAL QCHRID on the command line and press
Enter. Note the code page for future reference. Press F3 to exit.
7. Type DSPSYSVAL QAUTOCFG on the command line and press
Enter. Make sure the
Autoconfigure device parameter is
turned on (1). Press F3 to exit.
Example:
8. Type DSPSYSVAL QAUTORMT on a command line and press
Enter. Make sure the
Autoconfigure remote
controller
parameter is turned on(1). Press F3 to exit.
Example:
Display Line Description S1032BB0
Line description . . . . . . . . . : LIND ETHERNET
Option . . . . . . . . . . . . . . : OPTION *APPN
Category of line . . . . . . . . . : *ELAN
Link speed . . . . . . . . . . . . : LINKSPEED 10M
Cost/connect time . . . . . . . . : COSTCNN 0
Cost/byte . . . . . . . . . . . . : COSTBYTE 0
Security for line . . . . . . . . : SECURITY *NONSECURE
Propagation delay . . . . . . . . : PRPDLY *LAN
User-defined 1 . . . . . . . . . . : USRDFN1 128
User-defined 2 . . . . . . . . . . : USRDFN2 128
User-defined 3 . . . . . . . . . . : USRDFN3 128
Autocreate controller . . . . . . : AUTOCRTCTL *YES
Autodelete controller . . . . . . : AUTODLTCTL 1440
Bottom
Press Enter to continue.
F3=Exit
F11=Nondisplay keywords F12=Cancel
Display System Value
System value . . . . . : QAUTOCFG
Description . . . . . : Autoconfigure devices
Autoconfigure device . : 1 0=Off
1=On
Display System Value
Systemvalue.....: QAUTORMT
Description .....: Autoconfigureofremotecontrollers
Autoconfigure remote controller : 1 0=Off
1=On