User`s guide

Section 3: Basic Installation AXIS 5470e/570/670e User’s Manual

Notes:

Using RARP in UNIX Follow the instructions below to set the IP address using RARP.

AXIS 5470e/570

Ethernet Print Servers:

1. Append the following line to your Ethernet Address table. This is

typically located in the

/etc/ethers file:

Example:

2. Update, if necessary, your host table and alias name databases, as

required by your system.

3. If it is not already running, start the RARP daemon. This is

typically performed using the

rarpd -a command.

4. Restart the AXIS 5470e/570 to download the IP address.

Notes:

• The node address is equal to the serial number, which can be found

on the underside label of the AXIS 670e.

• The ARP command varies between different UNIX systems. Some BSD type

systems expect the host name and node address in reverse order.

• When you execute the ping command for the first time, you may experience

a significantly longer response time tha

n usual.

00:40:8c:10:00:86 npsname

• The Ethernet address is equal to the serial number, which can be

found on the underside label of the AXIS 5470e/570.

• If you are a IBM AIX user, you will probably not have access to a RARP

daemon. If this is the case, you can use either the ARP or BOOTP methods

instead.