User`s guide

AXIS 5470e/570/670e User’s Manual Section 3: Basic Installation

Using AXIS IP

Installer

Follow the instructions below to set the IP address of your AXIS

5470e/570/670e using the AXIS IP Installer:

Note:

1. Download the AXIS IP Installer to your host. The software is

available on the AXIS Product CD or on the Axis home page at

http://www.axis.com/.

2. Connect the AXIS 5470e/570/670e to the network. Note the

serial number that is located on the underside label of the AXIS

5470e/570/670e. You will need it in the proceeding steps.

3. Start the AXIS IP Installer.

4. Click the serial number of your AXIS 5470e/570/670e that

appears in the server list.

5. Enter the desired IP address in the designated IP address field and

click the Set IP address button.

6. The IP setting process will take approximately 10 to 40 seconds.

Click OK in the confirmation box that appears when the IP

address has been set.

Notes:

Using DHCP

Follow the instructions below to download the IP address using

DHCP:

1. Edit or create a scope in the DHCP manager of the DHCP

daemon. The entries included in this scope should contain the

following parameters:

You should not use AXIS IP Installer to set the IP adress if you have an active

DHCP server on your network.

• AXIS IP Installer uses the BOOTP and DHCP protocols to communicate

with the AXIS 5470e/570/670e. Make sure that at least one of these

protocols is enabled in your print server.

• Restart your AXIS 5470e/570/670e, if it does not show up in the server list.