User`s guide

Appendix A: Test Button AXIS 5470e/570/670e User’s Manual
302
Factory Default
Settings
Follow the instructions below to reset the AXIS 5470e/570/670e to
the factory default settings:
1. Remove the external power supply to switch off the AXIS
5470e/570/670e.
2. Press and hold down the test button, while you plug the external
power supply back in. Continue to hold down the test button,
until the network indicator begins to flash at one second intervals.
This should take at least 5 seconds.
3. Release the test button and wait until the network indicator
flashes at least five times.
4. Press and hold the test button again until the network indicator
remains constantly lit.
5. Restart the AXIS 5470e/570/670e by switching it off and on.
The AXIS 5470e/570/670e is now reset to factory default settings.
Note:
All parameters except Node Address (NODE_ADDR) and Internet Address
(IP_ADDR) are reset. If you want to change these parameters use any standard
Web browser. Please refer to Section 11 Management & Configuration
,
on page 169.