User`s guide

Section 3: Basic Installation AXIS 5470e/570/670e User’s Manual
28
Connecting a printer to the Token Ring Network
Follow the instructions below to connect a printer to the network via
the AXIS 670e print server.
Caution!:
1. Switch off the printer and disconnect the AXIS 670e external
power supply.
2. Locate the serial number, found on the label on the AXIS 670e,
and write it down. You will need this number later during the
network configuration.
3. Connect the printer to the LPT1, LPT2 or the COM1 port on
the AXIS 670e using an appropriate printer cable.
4. Slide the Ring Speed switch towards 4 or 16 depending on the
ring speed of your network.
5. Connect your AXIS 670e to the network using an Shielded
Twisted Pair (Media Type 1) or Unshielded Twisted Pair (Media
Type 3) cable.
6. Switch on the printer and connect the external power supply to
the AXIS 670e. The power indicator will light up. When the
network indicator starts to flash, the AXIS 670e is successfully
connected to the network.
7. Press and release the test button on the AXIS 670e to print a test
page. If the printer and the AXIS 670e are correctly connected,
the AXIS 670e internal test page will be printed.
• Make sure that the AXIS 670e external power supply is marked
with the correct voltage. Please refer to the Power supply table
on page 17.
• DO NOT connect or disconnect the network cabling while
AXIS 670e is powered on.