User`s guide

AXIS 5470e/570/670e User’s Manual Appendix A: SNA Parameter Overview
237
Updating parameters
This is most easily done from the internal web pages of your AXIS
5470e/570/670e. To set the parameters using a Web browser, you first
need to assign an IP address to the AXIS 5470e/570/670e. For
instructions on how to do this, refer to Assigning an IP address on
page 32.
Alternatively, you can update the parameters via FTP or by using
extended IBM printer emulation.
Using extended IBM printer emulation means setting up the AXIS
5470e/570/670e by printing a file containing extended IBM
emulation commands to it after you have established communication
with your IBM host. The configuration is started by inserting the
sequence
%CONFIG+ in your text. To protect your settings, a password
must be provided. By default, the password is
pass. You may then set
the parameter values directly using the syntax shown below:
Syntax:
When all parameters have been set the
SAVE command saves the
settings permanently. The
%CONFIG- command resumes normal
printing. In order to maintain backward compatibility, some
parameters must be preceded by a
%CONFIG++ command. See also
Appendix A The Parameter List on page 285.
<Parameter name> = <value> [, <value>];