User`s guide

Appendix A: SNA Parameter Overview AXIS 5470e/570/670e User’s Manual
234
LU_NAME LU Name Axxxxxxx, where
"xxxxxxx" is the
last 7 characters of
the AXIS
5470e/570/670e
serial number, in
reverse order, e.g.
if s.no. =
00 40 8C 1B 06 D4
the default LU
Name =
A4D60B1C.
This will be the
name of the APPC
device and
controller
created during
auto-configuration
5494 only This parameter defines the LU name of
the Print Server. The default value is
normally used.
If an RWS controller for this Print
Server is already defined on the AS/400
system, you may issue the DSPCTLD
command to make sure that this
parameter matches the Remote
location name (RMTLOCNAME).
The LU Name may comprise the letters
A-Z and/or numerals 0-9, but must
begin with a letter. The letters used
should all be in
UPPERCASE and a
maximum of 8 characters are allowed.
CP_NAME
(AXIS 570 only)
Control Point
Name
Axxxxxxx, where
"xxxxxxx" is the
last seven
characters of the
Print Server serial
number, in reverse
order, i.e. a print
server with serial
number 00 40 8C
1B 06 D4 will have
the default CP
Name A4D60B1C.
This will be the
name of the APPC
controller created
during auto-
configuration.
5494 only This parameter defines the Control
Point name of the Print Server. The
default value is normally used.
If an APPC controller for this Print
Server is already defined on the AS/400
system, you may issue the DSPCTLD
command to make sure that this
parameter matches the Remote control
point name (RMTCPNAME).
The CP Name may comprise the letters
A-Z and/or numerals 0-9, but must
begin with a letter. The letters used
should all be in
UPPERCASE and a
maximum of 8 characters are allowed.
H1_NW_NAME Host Network
Name
APPN 5494 only. This is the AS/400 Host System
Network Name.
This host parameter may be viewed by
issuing the DSPNETA command on the
AS/400 system. It is presented as the
"Local network ID" (LCLNETID).
Parameter Name Default Emulation Description