User`s guide

AXIS 5470e/570/670e User’s Manual Section 13: Using Logical Printers
223
Debugging using the
Hex Dump Mode
When hex dump mode is activated, the print data is printed as
hexadecimal byte values rather than characters; printer control
commands are also printed as hex values. This allows you to inspect
the control and print characters that are being sent to the printer,
which is a useful debugging facility for the more difficult printing
problems.
Example: Follow the instructions below to activate the hex dump mode for PR1:
1. Click admin and the Logical Printer Settings button.
2. Select the PR1 tab.
3. Set the Hex Dump Mode Enabled radio button to YES.
4. Click OK.
Note:
PostScript Settings When a logical printer is set for PostScript conversion, you must
specify the following:
• page size (default A4)
• page orientation (default Portrait)
• page format (see table below)
• font (default Courier)
Note:
The page length for hex dump printouts is determined by the lines per page value
of the PostScript page format parameter.
The PostScript font can be any font that is installed on the printer.
Page Format Parameter Default Value Description
Lines per page 66
Characters per line 0 0=disable line wrap
Characters per inch 100 100=10 characters per inch
Lines per inch 60 60 = 6 lines per inch
Left margin 30 30 = 3.0 mm
Top margin 50 50 = 5.0 mm