User`s guide

AXIS 5470e/570/670e User’s Manual Section 11: Management & Configuration
197
The Serial Printer Port
(AXIS 570/670e only)
HP JetAdmin does not support serial printer ports. If you must change
the default settings of the serial printer port of the AXIS 570/670e, it
is recommended that you use the AXIS NetPilot. This will become
necessary when you are installing a printer on your serial port. Follow
the steps below to change the serial port parameters using AXIS
NetPilot.
1. Start the AXIS NetPilot.
2. Select your AXIS 5470e/570/670e and click Install on the AXIS
NetPilot toolbar. Select with current configuration.
3. Your AXIS 5470e/570/670e has been transferred to the ‘Network
Print Servers’ folder. Select your AXIS 5470e/570/670e and click
the Property button on the AXIS NetPilot toolbar.
4. Select the Printer Ports tab.
5. Select COM1 from the Printer Port drop-down list.
6. Select XON/XOFF from the Handshake Protocol drop-down list,
set the Baud Rate to 38400 and select 1 stop bit. Click OK.
The settings in step 6 varies between different printer models. Please
refer to your printer documentation.
If your network supports TCP/IP you can also change the serial port
parameters by using the AXIS 5470e/570/670e Web interface.