User`s guide

AXIS 5400 User’s Manual Section 9: Setting Up - Macintosh
161
Setting Parameters In AppleTalk, you can change a limited number of the parameters of
the AXIS 5470e/570. You can:
• enable and disable binary data transfers for your printing
• select the type of binary transfer protocol to use
• specify the AppleTalk printer type
• set the IP address
However, by assigning an IP address to your AXIS 5470e/570, you
have access to all of print server’s parameters via any standard Web
browser or via FTP.
Refer to Section 11 Management & Configuration, on page 169 for
more information.
Example: The following example describes the how you set the AXIS 5470e/570
parameters in AppleTalk.
Important: DO NOT use the parameter values from this example when
configuring your AXIS 5470e/570. You should select values that are
appropriate for your printers and network settings.
Follow the instructions below:
1. Open the Chooser.
2. Select a network printer driver, any LaserWriter will do.
3. Select the printer port which name ends with "_CFG".
4. Close the Chooser.
5. Open a text editor, e.g. SimpleText.