User`s guide

AXIS 5470e/570/670e User’s Manual Section 7: Setting Up - Windows
137
11. Select the printer driver you want to install and click Next>.
12. Enter an appropriate name for your printer and click Next>.
13. Choose whether you want to share the printer with other network
users and click Next>.
14. Choose whether you want to produce a test page and then click
Finish.
Note:
Using the Microsoft
LPD monitor with
Windows NT 4.0
This section describes how to set up a Windows NT Server v4.0 for
LPR printing over the TCP/IP protocol, using the built-in Microsoft
LPD monitor.
Basic Setup If you have not already done so, you should perform the TCP/IP basic
setup procedures prior to installing a printer for LPD printing. These
procedures are defined in Assigning an IP address, on page 32 and
onwards.
Preparing for
LPR/LPD printing
In the Control Panel, click the Network icon. If the TCP/IP Printing
entry appears, then TCP/IP is already installed. Close the Network
folder and skip to Installing a printer on the next page.
Follow the following steps to prepare for LPR/LPD printing:
1. Open the Control Panel and click the Network icon.
2. Select Protocols.
3. Add TCP\IP Protocol.
4. Select Services.
5. Add MS TCP\IP Printing.
You can share the printer drivers you have installed with other AXIS Print System
users on your network. In AXIS Print System, check the Enable Driver Sharing box
in My Printers | Settings | Program Options | General