User`s manual

AXIS 5570e/AXIS 5670e User’s ManualSection 5: Setting Up - IBM Mainframe (zSeries)

Defining the

printer to PSF

Each AXIS 5570e/AXIS 5670e must be defined to PSF with a

PRINTDEV statement in the PSF startup procedure. The following

keywords are required on the PRINTDEV statement:

• IPADDR='xxx.xxx.xxx.xxx'

• PORTNO='xxxx'

The IPADDR parameter specifies the IP address of the AXIS

5570e/AXIS 5670e in dotted-decimal notation.

Note:

The PORTNO keyword specifies the TCP/IP port to use for the print

session. This port number must match the port number set up for the

AXIS 5570e/AXIS 5670e in Configuring the AXIS 5570e/AXIS

5670e, on page 71.

Below is a sample procedure,

APSWPROT, which you can modify to suit

your installation. The

PRINTDEV statement includes the required

IPADDR and PORTNO keywords. In the PRINTDEV example below, the

TCP/IP port number 5100 is used, but any port, larger that 1024, can

be used as long as the same port is set up in the AXIS 5570e/AXIS

5670e.

The

APSWPROT procedure contains JCL parameters to produce a

startup procedure for either 240-pel and 300-pel printers, but the

references to 300-pel resolution are commented out. To create

separate startup procedures, make two copies of

APSWPROT, and then

follow the commented instructions in

APSWPROT. Keep one

unchanged copy as your startup procedure for a resolution of 120 or

240 pels. In the second copy, delete or comment out all references to

240-pel resolution, and make all references to 300-pel resolution

active. This changed copy is your startup procedure for 300-pel

resolution.

Do not specify a host name in place of the dotted-decimal address.