User`s manual

AXIS 5570e/AXIS 5670e User’s ManualSection 5: Setting Up - IBM Mainframe (zSeries)

Verifying the

Communication:

1. Activate the connection you created in step 2 of the above SNA

Server - AXIS 5570e/AXIS 5670e connection procedures. The

status of the connection should be “active”.

2. Make sure the corresponding LU in the host is activated.

3. Activate the TN3270 connection to the AXIS 5570e/AXIS 5670e.

The LUA should change status to SSCP.

4. Check that the printer is connected to the AXIS 5570e/AXIS

5670e.

5. Send a print job from the host.

The AXIS 5570e/AXIS 5670e is now ready for use.

Notes:

NetWare for

SAA Server

To set-up a TN3270E connection to the AXIS 5570e/AXIS 5670e you

have to set up PU and LU definitions. This is done by following the

steps below:

1. Start the NWSAA Administrator.

2. Double-click the NWSAA Node. The panel below will appear.

3. Enter the Node ID for the host.

• You can check the status of the TN3270E connection by printing a test page

from the Print Server. This is done by pressing the test button once. Make

sure the TN3270E status (St:) line for your server connection is defined as

either:

•SSCP

•LU-1

•LU-3

• For additional information about configuring other TN3270E servers, refer

to the Technical Notes on www.axis.com