User`s manual

AXIS 5570e/AXIS 5670e User’s ManualSection 5: Setting Up - IBM Mainframe (zSeries)

Note:

Node Definitions The example below shows how the print server PU and LU definitions

may be coded in a local major node definition:

Note:

In the PU definition, IDNUM should be set to the five last digits of the AXIS

5570e/AXIS 5670e node address, NODE_ADDR. By default NODE_ADDR stands

for the five last digits of the AXIS 5570e/AXIS 5670e serial number.

In the path definition, PATH DIALNO should be comprised with its first two

digits equal to the place holder, the next two set to the SAP and the remaining

twelve digits set to the AXIS 5570e/AXIS 5670e Ethernet or Node address. By

default the Ethernet/Node address is identical to the AXIS 5570e/AXIS 5670e

serial number. A valid GRPNM must also be supplied.

In the LU definition, the LOCADDR number maps to the Logical Printer number

of the AXIS 5570e/AXIS 5670e. The first eight Local Addresses pass the printout

through Logical Printer 1-8. However, some IBM systems do not allow Local

Address 1 to be used for printing. Refer to Section 13 Using Logical Printers,

on page 170 for more information about logical printers.

* 5570e DSPU DEFINITION

DSPU5570e5570e PU CUADDR=E31, X

MODETAB=MODE3290, X

PUTYPE=2,ISTATUS=ACTIVE,MAXBFRU=1

DSPULU02 LU LOCADDR=2 X

SSCPFM=USSSCS, X

USSTAB=USSTAB, X

PACING=1, X

VPACING=2, X

ISTATUS=ACTIVE, X

LOGAPPL=MWTC, X

DLOGMOD=SCS5570e