User`s manual

AXIS 5570e/AXIS 5670e User’s Manual Section 4: Setting Up - AS/400 (iSeries)
41
6. Press Enter to display the Autocreate controller
(AUTOCRTCTL) parameter. Ensure that the AUTOCRTCTL
parameter is set to *YES. Press F3 to return to the command
line.
7. Type DSPSYSVAL QCHRID on the command line and press
Enter. Note the code page for future reference. Press F3 to exit.
8. Type DSPSYSVAL QAUTOCFG on the command line and press
Enter. Make sure the Autoconfigure device parameter is
turned on (1). Press F3 to exit.
Display Line Description S44A6643
Line description . . : LIND ETHERNET
Option . . . . . . . : OPTION *APPN
Category of line . . : *ELAN
Link speed . . . . .: LINKSPEED 10M
Cost/connect time . .: COSTCNN 0
Cost/byte . . . . . : COSTBYTE 0
Security for line. . : SECURITY *NONSECURE
Propagation delay. . : PRPDLY *MIN
User-defined 1 . . . : USRDFN1 128
User-defined 2 . . . : USRDFN2 128
User-defined 3 . . . : USRDFN3 128
Autocreate controller: AUTOCRTCTL *YES
Autodelete controller: AUTODLTCTL 1440
Press Enter to continue. Bottom
F3=Exit
F11=Nondisplay keywords F12=Cancel
Display System Value
System value . . . . . : QAUTOCFG
Description . . . . . : Autoconfigure devices
Autoconfigure device . : 1 0=Off
1=On