User`s manual

AXIS 5570e/AXIS 5670e User’s Manual Section 4: Setting Up - AS/400 (iSeries)
37
The AS/400 Host
System Checklist
If you are using AS/400 Version 3 Release 1 or higher, the AS/400
host in 5494 CU mode is automatically configured. The instructions in
this section describe this automated configuration procedure.
If you are using a pre-version 3 release, you must perform the
configuration procedure manually. If this is the case, please refer to
the Axis Web site for further documentation.
Note:
1. Type DSPNETA on the AS/400 command line and press Enter.
For future reference, note the values of the Local network
ID and Default local location parameters. Press F3.
Example:
The required parameter values are highlighted in bold.
2. Type WRKLIND *ELAN and press Enter:
to get a list of all line descriptions on the system. Type 5 in front
of the line description and press Enter.
You will find an AS/400 Parameter checklist in the AXIS 5570e/AXIS 5670e
User’s Guide where you can enter the values described in this section for future
reference.
DSPNETA
Display Network Attributes
System: S1032BB0
Current system name . . . . . . . . . . . . . . : S1032BB0
Pending system name . . . . . . . . . . . . . . :
Local network ID . . . . . . . . . . . . . . . . : > APPN
Local control point name . . . . . . . . . . . . : S1032BB0
Default local location . . . . . . . . . . . . . : > S1032BB0
Default mode . . . . . . . . . . . . . . . . . . : BLANK
APPN node type . . . . . . . . . . . . . . . . . : *ENDNODE
Data compression . . . . . . . . . . . . . . . . : *NONE
Intermediate data compression . . . . . . . . . : *NONE
Maximum number of intermediate sessions . . . . : 200
Route addition resistance . . . . . . . . . . . : 128
Server network ID/control point name . . . . . . : *LCLNETID
*ANY
Press Enter to continue. More...
F3=Exit F12=Cancel