User`s manual

AXIS 5570e/AXIS 5670e User’s Manual Section 7: Setting Up - NetWare
123
Section 7 Setting Up - NetWare
This section describes how to continue the installation of the AXIS
5570e/AXIS 5670e in the NetWare environment. Identify which
transport protocol you are running on your network and which
installation method you should use. Continue the installation by
selecting the appropriate installing instructions from the table below:
See “NetWare Administration” on page 156. for information on
Novell’s administration tools.
If you intend to operate your AXIS 5570e/AXIS 5670e in a multi-
protocol, mixed environment, you should also proceed to the other
relevant sections in this manual.
Installation
method
Transport
protocol
Action
NDPS TCP/IP
IPX/SPX
See “Setup using NDPS” on page 124.
- Public Access Printers, on page 124
- Controlled Access Printers, on page 130
iPrint iPrint over LPR See “Setup using iPrint” on page 143.and
See “Install a printer using AXIS LPR
Gateway Configuration Snapin” on page 146.
iPrint over IPP See “Setup using iPrint” on page 143.and
See “Install a printer with AXIS IPP Gateway
Configuration Snapin” on page 145.
Queue-based
printing
IPX/SPX
Basic
Configuration
To install using the AXIS NetPilot Installation
Wizard,
See “Basic Setup with AXIS NetPilot” on
page 149..
IPX/SPX
Advanced
configuration
If you need a more advanced installation
that is not covered by the AXIS NetPilot
Installation Wizard,
See “Advanced Installation using AXIS
NetPilot” on page 150..