User guide

System Information
AB SCIEX TripleTOF
®
5600/5600+ Instruments
20 of 116
System User Guide
D5033331 A
Dress Panel LEDs
Start Up the System
Before the system is turned on, make sure the site requirements specified in the Site Planning
Guide are met. This guide includes information on the mains supply and connections, source
exhaust, compressed air, nitrogen, roughing pump, ventilation, exhaust, and site clearance.
7 Gas 1 and Gas 2 (zero) supply connection Contact an AB SCIEX FSE.
8 Source exhaust gas (zero air or nitrogen)
supply connection
Contact an AB SCIEX FSE.
9 CAD gas (nitrogen) supply connection Contact an AB SCIEX FSE.
10 Source exhaust waste connection Contact an AB SCIEX FSE.
11 Roughing pump vacuum connection Contact an AB SCIEX FSE.
12 AC distribution panel Contact an AB SCIEX FSE.
13 Instrument power switch Refer to Start Up the System on page 20.
14 Cover over circuit breaker Refer to Start Up the System on page 20.
Use the power switch rather than the
circuit breaker to shut down the system.
15 Mains supply cable Refer to Start Up the System on page 20.
Table 1-1 Dress Panel LEDs
Instrument LED Color Name Description
Green Power Lit when the mass spectrometer is turned on.
Green Vacuum Lit when the proper vacuum has been achieved;
and flashing if the system is not at the proper
vacuum level (during pumpdown and venting.)
Red Fault Lit when the mass spectrometer encounters a
system fault.
Green Syringe
Pump
Status
Lit when the syringe pump is running.
Note: Before operating the instrument, read the safety information in the Safety and
Regulatory Information.
Figure 1-2 Left side view (Continued)
Item Description For more information...