User guide

Boeckeler Instruments, Inc. Pointmaker CPN-5600, CPN-6000 Color Video Markers - Page 85
Section Four: Using Markers Clearing Markers
ClearinG Markers
After you anchor markers (drawings, lines, frames, and pointers), you may want to
clear the screen of all or some of the markers before proceeding to the next point of
discussion. You can erase markers in one of the three following ways:
• ClearingAllMarkers
• UndoingtheMostRecentMarker
• ErasingMarkers
If you don’t want to clear markers, but just need to temporarily remove the marker
overlay, then use the Marker Overlay On/Off command(see Turning Off the
Marker Overlay, on page 89).
Clearing All Markers
Follow these instructions to clear the entire screen of markers.
From the Digitizing Tablet
SelecttheCLEARicononthetabletMenuStrip.
All markers disappear. An active pointer remains on screen unless the pointer
has been disengaged.
NOTE: Markers are cleared even if you are in PC Mode.
From Other Controllers
ActivatetheClearcommandforyourparticularcontroller.
All markers disappear. An active pointer remains on screen unless the pointer has been disengaged.
Undoing a Marker
Follow these instructions to undo a marker, beginning with the most recently
anchored marker or line segment. You can repeat this command as often as needed
until the screen is clear of markers.