User guide

Page 56 - Pointmaker CPN-5600, CPN-6000 Color Video Markers Boeckeler Instruments, Inc.
Serial Port Settings Section ree: CPN-5600 Menu System
Setting Comm Port Parameters
If you are assigning a port for communicating with another system(see Integrating
the CPN-5600 with Other Systems, on page 51), you must select either Control
Port or PVI to PVI as your device type. e CPN-5600 sup ports assigning only
one port for each type.
Control Port: Choose this option if the CPN-5600 is being used as an A/V
remote control command station, if it is being controlled remotely using
RS-232 commands, or if it is being connected to a PC.
PVI-to-PVI: Use this selection if the CPN-5600 is being used in a videocon-
ferencing system.
1. Select the appropriate device type in the Device Select dialog for the port
where you are connecting the other system (see Figure 3-24: Device Select
Dialog, on page 57).
Where a question mark is usually found, you will instead see an arrow.
NOTE: If the device type you desire for connecting to other systems is
unavailable, check to see if it is assigned to another port. Remem ber, only one
use of each is allowed.
2. Activate the arrow next to the device type to set its communication
parameters.
Figure 3-26: Control Port Dialog
e corresponding dialog appears.
Select the desired baud rate, parity, and stop bits.