User guide

Page 54 - Pointmaker CPN-5600, CPN-6000 Color Video Markers Boeckeler Instruments, Inc.
Serial Port Settings Section ree: CPN-5600 Menu System
NOTE: All the serial ports installed on your CPN-5600 are listed by
port number, with the device type displayed to the right of each num ber.
If the device type is in blue, it has been assigned through the autodetect
procedure at startup.
4. (optional) Select the device type you wish to have permanently assigned.
If the device type can be permanently assigned (some types cannot), the color
changes from blue to black. With the device permanently assigned, the next
time the CPN-5600 is powered up, the autodetect procedure will skip this
port. If the assigned device needs to be ini tialized at startup, it will be
initialized according to the device type listed.
NOTE: If the device type listed for a port cannot be permanently
assigned (for example: device type “unknown” or if you try to assign
more than one port for use with other systems(see Integrating the
CPN-5600 with Other Systems, on page 51)), there are two ways to change
it. e next two steps describe how.
5. (optional) Select the arrow to the right of the device type you wish to
change.
Figure 3-25: Device Select Dialog
e Device Select dialog appears.
is dialog presents a scrolling list of all device types currently supported by
the CPN-5600 in alphabetical order. e Page Up and Page Down buttons
allow you to quickly scroll through the names until you find the device type
you desire. When you locate and select the name you wish to assign, it will