User guide

Boeckeler Instruments, Inc. Pointmaker CPN-5600, CPN-6000 Color Video Markers - Page 53
Section ree: CPN-5600 Menu System Serial Port Settings
only the device type you specify. is speeds up the initialization process consider-
ably.
Integrating the CPN-5600 with Other Systems
Since only controller/marker device types are able to be recognized during the
initialization process, all other devices must be set up manually. e CPN-5600
allows you to manually adjust communication settings for either of its ports (see
Setting Comm Port Parameters, on page 54). is allows the CPN-5600 to be
integrated with:
1) an A/V system as a remote control command station where it can both
control A/V devices and mark over any images presented;
2) a remote control system which can send commands to the CPN-5600,
controlling its various functions, like AMX/Crestron.
Cisco Codec
e CPN-5600 supports the Cisco Codec through either of the serial ports.
Connect the two units using a straight-through serial cable, making note of which
serial port you use. When you get to the instructions for selecting the device type,
choose either “Codec” or “Cisco Codec”.
Designating a Serial Device Type
1. Activate the menu system (see Activating the Menu, on page 29).
e Main Menu appears (see Figure 3-1: Main Menu, on page 30).
2. Select DEVICES.
e Devices menu appears (see Figure 3-15: Devices menu, on page 48).
3. Select SERIAL PORTS.
Figure 3-24: Serial Ports Dialog
e Serial Ports dialog appears.