User guide

Page 40 - Pointmaker CPN-5600, CPN-6000 Color Video Markers Boeckeler Instruments, Inc.
Setting Video Output Section ree: CPN-5600 Menu System
5. Select a video type if you have no video input.
e unit senses the type of video input(NTSC or PAL) and selects it auto-
matically. If there is no video input and you are using the unit in Chalkboard
mode, the Type selection allows you to assign the appro priate video output for
your monitor.
Setting Video Output
e CPN-5600 gives you a wide range of video parameters for fine tuning your
video output.
1. Activate the menu system (see Activating the Menu, on page 29).
e Main Menu appears (see Figure 3-1: Main Menu, on page 30).
2. Select DISPLAY.
e Display menu appears (see Figure 3-6: Display Menu, on page 40).
3. Select VIDEO OUTPUT.
Figure 3-8: Video Output dialog
e Video Output dialog appears.
is dialog has screen ratio buttons of 4x3, 16x9 and 16x10. Selecting one of
the buttons allows you to then select from the resolutions and vertical refresh
rates listed below.