User guide

Boeckeler Instruments, Inc. Pointmaker CPN-5600, CPN-6000 Color Video Markers - Page 23
Section Two:Installation Power Up
If you add a controller at a later time, be sure to power down the Pointmaker,
install the new device, then power up.
Videoconferencing
e CPN-5600 supports videoconferencing (see Multipoint, on page 64).
Power Up
ese are the procedures for powering up.
1. PlugthepowercordintothebackofthePointmakerandthenintoany
groundedoutlet.
2. Plugthepowercordsfromanyvideosource(s),controller(s),and
display(s)intoanygroundedoutlet.
3. Turnoneachoftheconnectedunits,andthenpressthepowerbuttonon
thefrontpanelofthePointmaker.
NOTE: In order for the Pointmaker to properly sync with the video signals,
the sources should be turned on first.
After a moment, a Pointmaker splash screen will appear, followed by the
initializing of the ports, and ending with a copyright message.
After the startup process, a marker overlay will appear, displaying any
previously created markers.
If this process is different for you, recheck your installation and power up
again. Call Boeckeler Instruments for support at [phone] or (520)
745-0001 if it is still unsuccessful.
NOTE: To bypass port initialization, press ESC during startup.