User guide

Page 124 - Pointmaker CPN-5600, CPN-6000 Color Video Markers Boeckeler Instruments, Inc.
Overview Section Six:Using RS-232 Commands
(M) Video Input Type
e “M” commands tell the Pointmaker which type of video input is being used or
switched to, so that the proper signal is output from the Pointmaker. All “M” com-
mands override “A” (autodetect) commands.
RS-232 commands remain the same for each Pointmaker model, so models with
identical features continue to function with no code change. With this unit, each
“Video Input” port on the back panel is labeled with a unique number to simplify
port locating and troubleshooting for the system integrator. Notes are included to
clarify the correspondence to the new labels.
NOTE: Composite and Y/C are available but only at half their normal
resolution.
<Esc>(MC1N Composite 1 NTSC (labeled port 1 on rear panel)
<Esc>(MC2N Composite 2 NTSC (labeled port 2 on rear panel)
<Esc>(MYN Y/C NTSC (labeled port 3 and 4 on rear panel)
<Esc>(MV1 1st VGA port (labeled port 3 on rear panel)
<Esc>(MV2 2nd VGA port (labeled port 4 on rear panel)
<Esc>(MDA1 DVI-A1 (labeled port 3 on rear panel) Supports what was VGA
control code from previous model. Functions identically to MV1.
<Esc>(MDA2 DVI-A2 (labeled port 4 on rear panel) Supports what was VGA
control code from previous model. Functions identically to MV2.
<Esc>(MH1 1st HDMI port (labeled port 5 on rear panel)
<Esc>(MH2 2nd HDMI port (labeled port 6 on rear panel)
<Esc>(MH3 3rd HDMI port (labeled port 7 on rear panel)
<Esc>(MH4 4th HDMI port (labeled port 8 on rear panel)
<Esc>(MH5 5th HDMI port (labeled port 9 on rear panel)
(ME) Verify Dialog Response
e “ME” command allows you to respond to the “Verify” dialog.
<Esc>(MEØ Responds “OK”
<Esc>(ME1 Responds “Retry”
<Esc>(ME2 Responds “Cancel”