User guide

Page 114 - Pointmaker CPN-5600, CPN-6000 Color Video Markers Boeckeler Instruments, Inc.
Overview Section Six:Using RS-232 Commands
(DCT/DCA) Device Type COMM
e “DCT” and “DCA” commands help you control the recognition of device
types connected to Pointmaker COMM ports. Normally, at startup, the initializa-
tion setting(autodetect) for each COMM port causes the Pointmaker to run
through a list of procedures until it can determine the device type con nected to
each one. e DCT command allows you to limit the initialization pro cess for a
designated port to only look for a specified device. e DCA command allows you
to activate initialization of a COMM port immediately, without having to restart
the Pointmaker.
<Esc>(DCTptt Port “p” has device type “tt” assigned to it
p is a numeric value of 0-9 designating ports 1-10
tt is a numeric value designating the device type
corresponding to the table below
Example: <Esc>(DCT223
<Esc>(DCAp Port “p” is to be initialized immediately
p is a numeric value of 0-9 designating ports 1-10
NOTE: In the table below, “tt” is the two digit number assigned to the the device
type.
tt device type description
00 Mouse Microsoft mouse
01 Mouse 3 Microsoft plus (Logitech 3 button)
02 Mouse B Microsoft Ballmouse
03 Mouse MS Mouse Systems mouse
04 Mouse A Air Mouse
05 Digitizer A ACECAD Acecat II digitizer
06 Mouse A2 Air Mouse Generation II
07 Autodetect No mouse detected
08 Touch Scr I Elographics Intellitouch Touch Screen
09 Touch Scr A Elographics Accutouch Touch Screen
10 Touch Scr M Microtouch Touch Screen
11 Touch Scr K Keytec Touch Screen TS-232-B
12 Touch Scr S Symbios Touch Screen SYM93C2000
13 Touch Scr C CalComp 1000 DrawingSlate III
14 Touch Scr D3 Dynapro SC3 Touch Wall