User guide

Boeckeler Instruments, Inc. Pointmaker CPN-5600, CPN-6000 Color Video Markers - Page 99
Section Five:Image Mobility Image Manipulation
b)(digitaltablet)Activatethe“Save”button.
c)(keyboard)Type“Alt-F6”.
e “Alt-F6” keyboard command is programmed to save to the Computer
where TFTP is installed. e other two commands are dependent on the
Destination setting in the Capture dialog(see Setting the Destination for Saved
Files, on page 47).
If you want to use the tablet or touch screen commands, be sure to set the
Destination to USB first.
2. eimageissavedtothecomputeryouhavedesignated.
A counter appears at the lower-right portion of the screen, indicating the
percentage of the image saved to the TFTP server.
When the counter reaches 100, it disappears. e system is then ready to save
another image.
NOTE: Operation of the CPN-5600 will slow down during the saving
process.
e name of the file is determined by the settings in the File Defaults dialog
(see Figure 3-14: File Defaults dialog, on page 46).
Retrieving Images
Saved images can be retrieved using the “Get” command. A dialog appears,
allowing you to enter the number of the image you wish to on screen. When you
enter the number and activate the OK button, the image is dis played. To return to
the video input, again type the “Alt-F2” keyboard com mand.
To retrieve an image file from USB
1. Retrieveanimageinoneofthefollowingways:
a)(touchscreen)Touchtheappropriateareaifyouassignedthiscom-
mand.
b)(digitaltablet)Activatethe“Get”button.
c)(keyboard)Type“Alt-F3”.