User manual

44 Rockwell Automation Publication MOTION-UM003F-EN-P - March 2015
Chapter 1 Configure Integrated Motion Control Using Kinetix Drives
Configuring the Load
Feedback
The Load Feedback dialog box contains the information from the feedback
device that is directly coupled to the load-side of a mechanical transmission or
actuator.
The Load Feedback dialog box is available if the Feedback Configuration
specified on the General dialog box is Load or Dual.
Attributes that are associated with the Load Feedback dialog box are designated
Feedback 2.
Unlike the Motor Feedback dialog box, you must explicitly enter load feedback
device information on the Load Feedback dialog box, including the Feedback
Type. This is because the Load Feedback device is not built into the motor.
Default values are displayed based on the Feedback Type selected.
For your convenience, you can use this link
to the Module Properties dialog box for the
associated drive.