User manual

Rockwell Automation Publication MOTION-UM003F-EN-P - March 2015 239
CIP Drive Module Properties Appendix A
Clear Fault Clear Fault causes the Active Ring Supervisor to clear the Rapid Faults/Restore
Cycles fault.
Clear Fault is not displayed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• Online and the module is not configured as a ring supervisor
• Online and the module is not the Active Ring Supervisor
• The ring fault condition is not Rapid Fault/Restore Cycles
Advanced Configure advanced network properties.
Advanced appears dimmed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
Refresh Communication Refresh communication appears when communication with the module has failed.
Refresh communication attempts to refresh communication with the module.
Apply When you click Apply or OK, the information is automatically sent to the controller
if either of the following occurs:
• You are online in Program, Remote Program or Remote Run mode
• This controller is the owner controller
• You have changed the configuration of the module in the software
The controller tries to send the information to the module (if the connection of the
module is not inhibited). If you do not click Apply, your changes are not sent to the
controller.
Table 39 - Module Properties: Network Tab Descriptions
Parameter Description