User manual

238 Rockwell Automation Publication MOTION-UM003F-EN-P - March 2015
Appendix A CIP Drive Module Properties
Ring Faults Detected When the module is configured as a ring supervisor on the network, it displays the
number of times that a ring fault is detected by the Ring.
Ring Faults Detected has no value if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• The module is not configured as a ring supervisor
Reset Counter When the module is configured as a ring supervisor on the network, click Reset
Counter to reset the ring fault count of the module to zero.
Reset Counter appears dimmed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• The module is not configured as a ring supervisor
Supervisor Status When the module is configured as a ring supervisor on the network, it displays the
ring supervisor status of the module as the following:
• Active, the module is the Active Ring Supervisor
• Back up, the module is the back-up ring supervisor
• Cannot support current Beacon Interval or timeout, the module cannot support
either the beacon interval or timeout values of the current Active Ring
Supervisor
Supervisor Status has no value if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• The module is not configured as a ring supervisor
Ring Fault Last Active Node on Port 1
When the module is the Active Ring Supervisor on the network, it displays the IP
Address or MAC Address of the last active node on Port 1 if a ring fault has occurred.
Last Active Node on Port 1 is not displayed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• Online and the module is not a ring supervisor
• Online and the module is not the Active Ring Supervisor
Last Active Node on Port 2
When the module is the Active Ring Supervisor on the network, it displays the IP
Address or MAC Address for the last active node on Port 2 if a ring fault has
occurred.
Last Active Node on Port 2 is not displayed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• Online and the module is not configured as a ring supervisor
• Online and the module is not the Active Ring Supervisor
Verify Fault Location Verify Fault Location causes the active ring supervisor to verify the last node fault
location on port 1 and port 2 of the module. The last fault location that has
occurred continues to display until you verify the fault.
Verify Fault Location is not displayed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• Online and the module is not configured as a ring supervisor
• Online and the module is not the Active Ring Supervisor
Status When the module is the Active Ring Supervisor on the network, Status displays the
ring fault condition on the network as either of the following occurs:
• Partial Network Fault
• Rapid Fault/Restore Cycles
Status is not displayed if either of the following occurs:
• Offline
• Online and a module mismatch or communication error has occurred
• Online and the module is not configured as a ring supervisor
• Online and the module is not the Active Ring Supervisor
• The ring fault condition is not Partial Network Fault or Rapid Fault/Restore
Cycles
Table 39 - Module Properties: Network Tab Descriptions
Parameter Description