User manual

Rockwell Automation Publication MOTION-UM003F-EN-P - March 2015 231
CIP Drive Module Properties Appendix A
Internet Protocol Tab
The Internet Protocol tab lets you configure EtherNet/IP settings. You must be
online to configure EtherNet/IP settings. These settings appear dimmed when
you are offline. They also appear dimmed when you are online and there is a
module mismatch or a communication error occurs. BOOTP or DHCP is not
supported.
If you use the switches on the module to set the EtherNet/IP address, the IP is set
automatically. If the module does not support setting the IP address via switches,
this option does not display.
You can disable IP settings set by switches on the module. Change the switch
settings on the module and then reset the module either by cycling power to the
module or by clicking Reset on the Module Info tab.
Figure 12 - Internet Protocol