User`s manual

Macintosh
Section 7: Setting Up - Macintosh AXIS 5400+ User’s Manual
76
Setting Parameters In AppleTalk, you can change a limited number of the parameters of
the AXIS 5400+. You can:
• enable and disable binary data transfers for your printing
• select the type of binary transfer protocol to use
• specify the AppleTalk printer type
• set the IP address
However, by assigning an IP address to your AXIS 5400+, you have
access to all of print server’s parameters via any standard Web browser
or via FTP. Refer to Section 9 Management & Configuration, on page
92 for more information.
Example: The following example describes the how you set the AXIS 5400+
parameters in AppleTalk.
Important: DO NOT use the parameter values from this example when
configuring your AXIS 5400+. You should select values that are
appropriate for your printers and network settings.
Follow the instructions below:
1. Open the Chooser.
2. Select a network printer driver, any LaserWriter will do.
3. Select the printer port which name ends with "_CFG".
4. Close the Chooser.
5. Open a text editor, e.g. SimpleText.