User`s manual

NetWare
AXIS 5400+ User’s Manual Section 5: Setting Up - NetWare
53
Section 5 Setting Up - NetWare
This section describes how to continue the installation of the AXIS
5400+ in the NetWare environment. Identify which transport
protocol you are running on your network and which installation
method you should use. Continue the installation by selecting the
appropriate installing instructions from the table below:
If you intend to operate your AXIS 5400+ in a multi-protocol, mixed
environment, you should also proceed to the other relevant sections in
this manual, namely:
Section 4 Setting Up - Windows, on page 32
Section 6 Setting Up - OS/2, on page 66
Section 7 Setting Up - Macintosh, on page 72
Section 8 Setting Up - UNIX, on page 78
Installation
method
Tr a ns p or t
protocol
Action
NDPS
TCP/IP
IPX/SPX
See Setup using NDPS, on page 54
Proceed with Installing the AXIS 5400+ in an NDPS environments, on
page 54.
Queue based
printing
IPX/SPX
Basic
Configuration
To install using the AXIS NetPilot Installation Wizard, see Basic Setup
with AXIS NetPilot, on page 56
IPX/SPX
Advanced
configuration
If you need a more advanced installation that is not covered by the AXIS
NetPilot Installation Wizard, continue to Advanced Installation using
AXIS NetPilot, on page 59
Pure IP See Basic Queue-based printing over IP, on page 62