User`s manual

Windows

AXIS 5400+ User’s Manual Section 4: Setting Up - Windows

8. Select the AXIS Port you wish to add and then click OK. The

port appears as <name>.LP1, where <name> is AX followed by

the last six digits of the AXIS 5400+ serial number, e.g. xxx

(default serial no.).

9. Click on Settings. Choose whether error condition pop-up

messages are to be displayed by checking the box in the Configure

Axis Ports dialog. Click OK.

Using the Microsoft

LPD monitor with

Window NT 3.5x

This section describes how to set up a Windows NT Server

v3.5 and v3.51 for LPD printing over the TCP/IP protocol, using the

built-in Microsoft LPD monitor.

Basic Setup If you have not already done so, you should perform the TCP/IP basic

setup procedures prior to installing a printer for LPD printing. These

procedures are defined in Assigning an IP address, on page 22 and

onwards.

Install the TCP/IP

Protocol Stack

In the Control Panel, click the Network icon. If the TCP/IP Printing

entry appears, then TCP/IP is already installed. Close the Network

folder and continue with Installing a printer on the next page.

Follow these steps to install the TCP/IP protocol stack:

1. In the Control Panel, select Network.

2. Click Add Software...

3. Select “TCP/IP Protocol and related components” and then

click Continue.

4. Check “TCP/IP Network Printing Support” and then click

Continue.

5. Select path and then click Continue.

6. Click OK in the Network Settings dialog box.