User`s manual

Windows

Section 4: Setting Up - Windows AXIS 5400+ User’s Manual

Client-Server Printing AXIS Print System needs only to be installed on one server to perform

client-server printing. The installed printers must be configured to be

shared to allow clients to use them. Pop-up messages should not be

enabled on the server, as they will not be displayed on the client

platforms.

TCP/IP Printing in Windows 95, 98, NT and 2000

Install AXIS Print System ver. 1.20 on your Windows 95, 98, NT or

2000 client, if you have not already done so. This software can be

downloaded from the AXIS Product CD or from the Axis web

http://www.axis.com. To enable printing in the TCP/IP

environment, you must ensure that the TCP/IP protocol is enabled on

your client.

Set the print server’s

IP address

See Assigning an IP address, on page 22.

Add a printer to ’My

Printers'

The network printers and Axis print servers that are available in your

network are displayed in the Available Printers/Print Servers window.

Only printers connected to Axis print servers with firmware versions

6.00 or higher will appear in the Available Printers/Print Servers

window.

Follow these instructions to add a network printer to My Printers:

1. Select the Available Printers/Print Servers tab.

2. Select the network printer you wish to add to your My Printer list

and click the Add to My Printers button or select Add (Typical)

to My Printers from the Printer menu. The AXIS Print System

Add Printer Wizard will start. Follow the instructions given on

the screen in order to install an appropriate driver.