User`s manual

NetWare
UNIX
Windows
OS/2
Macintosh
Section 13: The Parameter List AXIS 5400+ User’s Manual
144
--- TCP/IP MENU
TCP_ENB.: YES
TCP/IP Enabled
INT_ADDR.: 0000
Internet Address
DEF_ROUT.: 0000
Default Router Address
(0.0.0.0 for no router)
NET_MASK.: 0000
Net Mask
(e.g. 255.255.255.0 for class C, 0.0.0.0 for auto-sense)
PROS_PWD.: netprinter
PROS Password
PROS_PRT.: 35
PROS TCP Port Number
LPD_BANN.: OFF (OFF, AUTO, LAST)
LPD Banner Page Mode
DHCP_ENB.: YES
DHCP Enabled
AUTOIP_ENB.: YES
Auto-IP enabled
BOOTP_ENB.: YES
BOOTP Enabled
RARP_ENB.: YES
RARP Enabled
WINS_ENB.: YES
WINS Enabled
WINS_ADDR1.:0000
Primary WINS Server Address
WINS_ADDR2.:0000
Secondary WINS Server Address
NBT_SCOPE_ID.:
NBT Scope ID
(Defines the NetBIOS scope to be used with WINS name registration)
DNS_ENB.: YES
DNS Enabled
DNS_ADDR1.: 0000
Primary DNS Server Address
DNS_ADDR2.: 0000
Secondary DNS Server Address
DOMAIN_NAME.:
Domain Name (Defines the domain to which the AXIS 5400+ belongs)
SMTP SERVER:
Mail Server that uses Simple Mail Transfer Protocol.
SLP_SCOPE_LIST.: DEFAULT
Defines the SLP scope to which the AXIS 5400+ belongs.
RTN_OPT.: NO
Reverse Telnet Options Enabled
RTEL_PR1.: 0
PR1 Reverse Telnet Port Number
RTEL_PR2.: 0
PR2 Reverse Telnet Port Number
RTEL_PR3.: 0
PR3 Reverse Telnet Port Number
RTEL_PR4.: 0
PR4 Reverse Telnet Port Number
RTEL_PR5.: 0
PR5 Reverse Telnet Port Number
RTEL_PR6.: 0
PR6 Reverse Telnet Port Number
RTEL_PR7.: 0
PR7 Reverse Telnet Port Number
RTEL_PR8 : 0
PR8 Reverse Telnet Port Number
--- SNMP MENU
READ_COM.: public
Read Community
WRT_COM.: pass
Read/Write Community
TRAPADDR.: 0000
Trap Address
TRAP_COM.: public
Trap Community
SYS_NAME.:
System Name
SNMP_AUT.: DISABLE (DISABLE, ENABLE)
Authentication Failure Trap
TRAP_PRT.: DISABLE (DISABLE, ENABLE)
Printer Failure Trap
--- NETWARE MENU
NETW_ENB.: YES
NetWare Enabled
NETW_TRANSPORT_PROTOCOL.: DUAL_STACK (IPX_ONLY,IP_ONLY,
DUAL_STACK)
NetWare Transport protocols Enabled
JOB_CHECK_DELAY.: 5
Job Check Delay
(Print Server queue polling interval)
CONF_CHECK_DELAY.: 300
Configuration Check Delay
(Interval between automatic configuration checks)
FR_802_3.: YES
IEEE 802.3 Frame Type Enabled
FR_ETH_2.: YES
Ethernet II Frame Type Enabled
FR_802_2.: YES
IEEE 802.2 Frame Type Enabled
FR_SNAP.: YES
SNAP Frame Type Enabled
NCP_BURST_MODE.: YES
NCP Burst Mode Enabled (Requires Restart)